![]() ![]() Please read these instructions completelyīefore operating this product. PRODUCT REGISTRATION, PLEASE VISIT OUR WEBSITE AT. Imation ANZ Pty Ltd Unit 2, 1 Coronation Avenue, Kings Park, NSW 2148 Specifications are subject to change without notice.įOR ADDITIONAL SET-UP, OPERATING ASSISTANCE OR and other countries.Ĭompatible with your iPod or iPhone device withĭocking capability. IPhone, iPod, iPod classic, iPod nano and iPod touch are trademarks of Apple Inc., registered in the U.S. Please note that the use of this accessory with iPod or iPhone may affect wireless performance. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards. “Made for iPod” and “Made for iPhone” mean that an electronic accessory has been designed to connect specifically to iPod or iPhone, respectively, and has been certified by the developer to meet Apple performance standards. The TDK Life on Record Logo is a trademark of TDK Corporation and is used under a trademark license from TDK Corporation. Imation is a registered trademark of Imation Corp. The iPod or iPhone will charge as long as this unit is connected with the AC adapter.Gently slide in the iPod or iPhone so the connector on the iPod or iPhone slides onto the connector on this unit.Rotate the adjustable iPod support knob counter-clockwise to raise or clockwise the lower the support position as desired.Antenna: For best FM reception, plug the included FM Antenna Wire into the FM Antenna jack on the rear of the unit. After you have adjusted the volume setting, if you turn the unit off and then on again, the volume level will be set to the level prior to turning the unit off.NOTES: To turn this unit off, press the POWER button. CHARGING: When the iPod or iPhone is inserted into the dock, whether this unit is on or off, the battery will charge until it is full. ![]() To remove the iPod or iPhone, gently slide it off the connector.NOTES: When the iPod or iPhone is connected to this unit, and in iPod mode, it will be in the Pause mode and the Pause icon will flash in the display. Open the battery door by pushing in on the tab, then removing the door. Two (2) “AAA” size batteries can also be used to provide a back-up for the clock and alarm times and radio presets for this unit as follows: 1. Only use the supplied AC adapter which has the following specs: DC 5.9V.NOTES: Remove both the DC plug and the AC-IN plug to disconnect the AC adapter when not in use. Connect the other end to a wall outlet having 240V AC, 50 Hz. Insert the small end of the AC adapter into the DC In jack (located on the rear of the unit). After finishing the call, the music will resume playing. While there is an incoming call for the iPhone, the music will pause.NOTE: To turn this unit off, press the POWER button Rotate the Volume control clockwise to increase the volume or counter- clockwise to decrease the volume. (please use the power supply accompanied with this unit only) ![]()
0 Comments
Leave a Reply. |